Is there a way to fix this? I hope I've been exhaustive! I also tried to add the Generic QUAD SPI Controller II Intel FPGA IP, with configuration device type N25Q016A13ESF40, connecting the same sources to the same ports as seen in the qspi (arduino_generic_quad_spi_controller2) module, but I get the error: Error: MKRVIDOR4000_template_mbox_lite_sys.nios2_gen2_0.data_master: generic_quad_spi_controller2_0.avl_csr (0x0.0x3f) overlaps sdram.s1 (0x0.0x7fffff) (I would like to post the log but it exceeds the characters' maximum allowed length, if it is allowed I would post it in 2 following messages)Ä«etween the patching lines, i noticed that lots of hunks failed but I can't figure out why. Searching for this problem in the MKRVIDOR4000 forum, I saw that the solution is to correctly patch Quartus with the file "apply_quartus_patches.sh" from the VidorBitstream-release archive, so I ran it from Linux terminal (I'm using Ubuntu 20.04), with Nios 2 Command Shell opened The component had an unexpected internal error. The arduino_generic_quad_spi_controller2 IP is visible from the Quartus Platform Designer, but when I try to add it in MKRVIDOR4000_template_mbox_sys.qsys, Quartus says: Error: An instance of Arduino Generic QUAD SPI controller II Intel FPGA IP could not be created. I'm trying to build the MKRVIDOR4000_template_mbox_lite project but, while generating the HDL from MKRVIDOR4000_template_mbox_lite_sys.qsys file, I get the following error: Component arduino_generic_quad_spi_controller2 18.1 not found or could not be instiantiated
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |